Greetings,
I am new to the forum and need some help troubleshooting an issue. I have a Raspberry Pi 5, using Raspian 64bit, and trying to set up an Argon Neo 5 m.2 NVMe case. I am sure it is opperator error/ignorance however, I don't know the next steps.
I am using MAC OS 12.7.5, ether net connection, and Terminal. I was able to SSH into my Pi 5 and completed the first step of the Argon setup instructions. I attempted a reboot, not sure if it did reboot, and tried to SSH back in to my Pi 5.
I am getting the port: 22 is timed out. Also my Wi-Fi network says my Pi 5 is offline however, it is powered up and connected. I have the 64GB SD card flashed with Raspian 64 and the M.2 NVMe drive flashed with Home Assistant which is my ultimate goal. I am attempting to have my Pi 5 run my Home Assistant.
Not the greatest of asks, but I seem to be stepping in it every step I take.
Any assistance would be appreciated, thank you.
I am new to the forum and need some help troubleshooting an issue. I have a Raspberry Pi 5, using Raspian 64bit, and trying to set up an Argon Neo 5 m.2 NVMe case. I am sure it is opperator error/ignorance however, I don't know the next steps.
I am using MAC OS 12.7.5, ether net connection, and Terminal. I was able to SSH into my Pi 5 and completed the first step of the Argon setup instructions. I attempted a reboot, not sure if it did reboot, and tried to SSH back in to my Pi 5.
I am getting the port: 22 is timed out. Also my Wi-Fi network says my Pi 5 is offline however, it is powered up and connected. I have the 64GB SD card flashed with Raspian 64 and the M.2 NVMe drive flashed with Home Assistant which is my ultimate goal. I am attempting to have my Pi 5 run my Home Assistant.
Not the greatest of asks, but I seem to be stepping in it every step I take.
Any assistance would be appreciated, thank you.
Statistics: Posted by epratt_11 — Fri May 24, 2024 8:10 pm — Replies 1 — Views 47