I have a new Raspberry Pi m.2 Hat+ with a Pi5 and a 1tb SSD.
I am doing a new install, the Pi is working booting from the SD card.
How do I verify the SSD is visible to the PI? There is an orange light on on the HAT, but it wont boot to the NVME.
What should I look for?
So far I have tried:
The problem may be my SSD I purchased. It's a SATA Drive, a replacement is on the way.
I am doing a new install, the Pi is working booting from the SD card.
How do I verify the SSD is visible to the PI? There is an orange light on on the HAT, but it wont boot to the NVME.
What should I look for?
So far I have tried:
Code:
pi@raspberrypi:~$ sudo lspci00:00.0 PCI bridge: Broadcom Inc. and subsidiaries Device 2712 (rev 21)01:00.0 Ethernet controller: Device 1de4:0001pi@raspberrypi:~$ sudo lsblkNAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINTSmmcblk0 179:0 0 59.5G 0 disk ├─mmcblk0p1 179:1 0 512M 0 part /boot/firmware└─mmcblk0p2 179:2 0 59G 0 part /The problem may be my SSD I purchased. It's a SATA Drive, a replacement is on the way.
Statistics: Posted by schappet — Thu Jun 13, 2024 9:39 pm — Replies 1 — Views 76