Hi,
I am having an issue getting the display to appear on the PI5.
When I first started playing around with the Pi, I could boot into Ubuntu and get to the settings, but I had to take my eyes off it for 10-15 mins. I came back to the monitor, and the pi was very hot. I unplugged the pi and let it cool but now the pi doesn't boot.
I noticed that when the SD card is plugged in the light starts to fade in and out so I switched to a USB stick, but still nothing.
Now I'm changing settings around in the config.txt. Here's what it looks like now:
Here is the hardware I use:
- pi power supply official
- pi5
- SanDisk Ultra 64GB microSD
- Lexar 64 GB flash drive
If anyone can help me, your help would be much appreciated. If there are other posts with similar issues please link them here so I can take a look.
Hopefully, I didn't brick the pi5 I just bought.
Thank you
I am having an issue getting the display to appear on the PI5.
When I first started playing around with the Pi, I could boot into Ubuntu and get to the settings, but I had to take my eyes off it for 10-15 mins. I came back to the monitor, and the pi was very hot. I unplugged the pi and let it cool but now the pi doesn't boot.
I noticed that when the SD card is plugged in the light starts to fade in and out so I switched to a USB stick, but still nothing.
Now I'm changing settings around in the config.txt. Here's what it looks like now:
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# --------------------------------------- NEW CHANGES HEREhdmi_safe=1hdmi_force_hotplug=1hdmi_group=1hdmi_mode=76# ----------------------------------------# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[cm5]dtoverlay=dwc2,dr_mode=host[all]- pi power supply official
- pi5
- SanDisk Ultra 64GB microSD
- Lexar 64 GB flash drive
If anyone can help me, your help would be much appreciated. If there are other posts with similar issues please link them here so I can take a look.
Hopefully, I didn't brick the pi5 I just bought.
Thank you
Statistics: Posted by kickTanjerine — Thu Nov 07, 2024 6:32 am — Replies 0 — Views 3