As far as I can tell, the only change I'd need to do is add to and then reboot. But this doesn't appear to actually change which antenna output is used.
How do I switch to using the antenna socket on the CM4?
I have a couple of CM4 and have configured one as an AP and had the other connect to it. There's absolutely no change in signal level (`ifconfig wlan0`) when I try to get them to use the antenna socket. I'd expect at least a point or two of difference.
Code:
dtparam=ant2Code:
/etc/firmware/config.txtHow do I switch to using the antenna socket on the CM4?
I have a couple of CM4 and have configured one as an AP and had the other connect to it. There's absolutely no change in signal level (`ifconfig wlan0`) when I try to get them to use the antenna socket. I'd expect at least a point or two of difference.
Statistics: Posted by ouroborus — Wed Dec 25, 2024 6:32 pm — Replies 0 — Views 20